Configure Fiberhome SR – 1041Y

Look Firmware version : RP0100

STEP 1: Open up a web browser and enter the default gateway’s IP address (192.168.1.1) in the Address\URL field.

STEP 2: Enter the username and password (superadmin /f1ber@dm!n) according to device label

STEP 3: Click SIGN IN to log in to the Web page.

STEP 4: Click Advance Step

STEP 5: Click WAN Service

STEP 6: Select Connection name – 1_INTERNET_R_VID_500

STEP 7: Select Package Type: PPPoE

STEP 8: Select Mode: Route

STEP 9: Select IP Protocol Type: IPv4/ IPv6

STEP 10: Enable VLAN and enter VLAN ID 500

STEP 11: Select Service Type: INTERNET

STEP 12: Key in the PPP Username & Password

STEP 13: Select Dial Mode: Automatically

STEP 14: Select WAN Get IP Mode: PPPoE

STEP 15: Select Get IPv6 Prefix Mode: PrefixDelegation and Get IPv6 Address Mode: DHVPv6

STEP 16: Select Bound Ports: LAN 1,LAN 2, LAN 3, SSID 1 & SSID 6.

STEP 17: Click Apply to save config

STEP 18: *Reboot RG by power on off the device power button.

STEP 19: Select Status

STEP 20: Select WAN

STEP 21: Verify Connection Status: Connected

WiFi Configuration Setting

STEP 1: Open up a web browser and enter the default gateway’s IP address (192.168.1.1) in the Address\URL field.

STEP 2: Enter the username and password (superadmin /f1ber@dm!n) according to device label

STEP 3: Click SIGN IN to log in to the Web page

STEP 4: Select Basic Setup STEP 5: select WLAN STEP 6: Click Basic Config 2.4GHz STEP 7: Configure the SSID STEP 8: Click Apply to save the configuration. STEP 9: Repeat STEP 6 to STEP 6 for Basic Config 5GHz

STEP 10: Click Security Setting 2.4GHz STEP 11: Key In WPA Preshare key : password STEP 12: Click Apply to save the configuration STEP 13: Repeat STEP 10 to STEP 12 for Security Setting 5GHz

 

 

MENU