SETTING BRIDGE MODE RIGER ADM-206

ROUTER MODE CONNECTION – DYNAMIC IP

Pastikan modem RIGER ADM 206 berkeadaan baik

 

STEP 1: Open your web browser and go to http://192.168.1.1

STEP 2: Enter the username and password (tmadmin/Adm@xxxx)

<Note: XXXX = last 4 digit of Mac Address>.

STEP 3: Click “Login” to log in to the Web page.

 

STEP 4: Click on “Setup” and select “Internet Setup”. Then choose “Add” to configure WAN interface.

 

STEP 5: Default in Modem ATM PVC Configuration is “(VPI :0 / VCI :35)”

STEP 6: Choose and select connection type as below :-

•Protocol : BRIDGING.

•Encapsulation Mode : LLC/SNAP-BRIDGING.

STEP 7: Click “Next” to save the configuration.

 

STEP 8: Click “Apply” to save the configuration.

 

STEP 9: “WAN Setup” will show the summary of newly added Bridge setting.

 

STEP 10: Click the “Status” and select the “Device Info” to verify Bridge status connection.

STEP 11: Configure modem dialer on PC. Connect a RJ45 LAN cable from LAN Port modem to the LAN Port PC.

STEP 12: Open the dialer. Fill in your account “PPP username” and “PPP password”. Click on “Connect” button to proceed.

HOW TO SETTING MODEM RIGER ADM-206

 

ROUTER MODE CONNECTION – DYNAMIC IP

Pastikan modem RIGER ADM 206 berkeadaan baik

STEP 1: Open your web browser and go to http://192.168.1.1

STEP 2: Enter the username and password (tmadmin/Adm@xxxx)

<Note: XXXX = last 4 digit of Mac Address>.

STEP 3: Click “Login” to log in to the Web page.

 

Follow video youtube dibawah untuk step by step cara config modem RIGER ADM-206:

RECONFIGURE WIFI NETIS

 

How to configure your Wi-Fi

  1. Launch Web Browser and enter the default’s gateway’s IP address (192.168.1.1) in the address bar.
  2. Enter Username and Password. Username = tmadmin Password = Adm@xxxx (xxxx refers to last four digits of MAC address)

 

 

  1. Choose WLAN -> wlan0 (2.4GHz) Basic Setting, Enable 2.4GHz WLAN and configure the SSID.
  2. Untick the Disable WLAN Interface to enable Wireless.
  3. Fil in the SSID.
  4. Click Apply Changes to save the settings.

 

  1. Click Security tab to configure.
  2. Select Encryption type and Pre-Shared Key Format.
  3. Enter the Pre-Shared Key.
  4. Click Apply Changes to save configure.

 

  1. Choose WLAN -> wlan0 (5GHz) Basic Setting, Enable 5GHz WLAN and configure the SSID.
  2. Untick the Disable WLAN Interface to enable Wireless.
  3. Fil in the SSID.
  4. Click Apply Changes to save the settings.

 

 

  1. Click Security tab to configure.
  2. Select Encryption type and Pre-Shared Key Format.
  3. Enter the Pre-Shared Key.
  4. Click Apply Changes to save configure.

How To Upgrade firmware modem riger DB120WL

Cara upgrade & setting terbaik modem riger DB120WL

Lepas dah selesai factory reset, sila configure modem RIGER 120WL seperti biasa

Terima Kasih kerana membaca panduan mudah setting terbaik modem riger DB 120WL

 

Unifi Plus Box (UPB) STEP BY STEP INSTALLATION

 Cara-Cara Install UPB by video . tq to Unifi.

 

1.Power indicator : GREEN – active mode,  RED – standby mode

2.Network link indicator : GREEN – Connected to network,                           RED – No network connection

3.Bluetooth indicator : BLINKING GREEN – unifi Plus Box is receiving signals from the remote control

1.Power interface

2.LAN : Ethernet interface

3.HDMI : HD video interface

4.AV : SD video interface

5.SPDIF : SPDIF port

Gambarajah remote UPB

Purchase PIN (default:123456). 




 




 

 



 

 




 




 

 

 

 

9 SEBAB KENAPA WIFI SLOW

Perkongsian 10 sebab kenapa wifi slow yang secara tak langsung bagi kesan kepada speed internet.

1. Halangan
Halangan seperti dinding batu, alat elektrikal seperti microwave oven dan peranti wireless dan bluetooth yang lain, punca signal wifi tak stabil.

2. Jarak
Kalau PC atau peranti korang jauh dari router pun antara punca wifi lemah dan speed menurun.

3. Network card tak update
Kalau dah lama tak update, boleh cuba update sekarang.

4. Channel congested
Banyak peranti wireless berkongsi channel yang sama dan bertindih antara satu dengan lain.

5. Antenna low gain
Bila antenna low gain coverage tak boleh stabil dan pergi jauh.

6. Modem yang outdated
Mungkin internal antenna wifi modem korang pun low gain. Kalau internal antenna yang macam ni, takde cara lain melainkan tukar modem baru.

7. Router tersorok
Jangan letak router atas lantai atau tempat terlindung, letak tempat tinggi dan lapang.

8. Router tak pernah reboot
Setkan automatik reboot dalam modem setting.

9. VPN
Kebanyakan VPN sekarang ni server dah banyak down sebab ramai sangat guna, free lah katakan.

APA BEZA WiFi 2.4GHz dengan 5GHz?

Adakah signal Wi-Fi di rumah anda good quality/excellence/full BAR?

 

 Tonton video youtube dibawah:

MENU